Facilities, apartments and condominiums often suffer from odors from the garbage rooms that migrate from the holding area to the garage or on the floors through the chute system.
Different stand-alone systems can be used to eliminate these problems by destroying bacteria and removing chemical and biological odors. The objective is to rapidly recirculate the air in the room in front of UV-C to break down bacteria’s DNA, and in front of UV-V to oxidize the chemical decay molecules while minimizing the residual ozone.
The Sanuvair® S600:
This stand-alone UV air purifier incorporates a variable blower of 300 to 600 cfm, an aluminum mesh washable prefilter to capture particulates and 3 full UV-V oxidizing lamps. According to the customer’s needs, one, two or three UV-V 6.5’’ U shaped lamps are lighted up.
Room size: up to 8,000 cubic feet
Suggested installation Sanuvair® S600
The Sanuvair® S300 OZD:
This stand-alone UV air purifier incorporates a two-speed blower of 220/300 cfm, a 2” pleated prefilter to capture particulates, 1 UVC/UVV lamp and 1 full UV-V oxidizing lamp tied with 20 ft of wiring to an ozone controller set at 0.025 ppm. The controller will sample the air every minute and trigger off the UV-V lamp if more than the set point of ozone is detected. It also comes with 2 extra prefilters.
Room size: up to 3,000 cubic feet
Suggested installation Sanuvair® S300 OZD
This stand-alone UV air purifier incorporates a blower of 1,000 cfm, 2 x 1” pleated prefilter to capture particulates, 1 UVC/UVV “J” shaped 16” lamp and 1 full UV-V “J” shaped 16” oxidizing lamp tied with 20 ft of wiring to an ozone controller set at 0.025 ppm. The controller will sample the air every minute and trigger off the UV-V lamp if more than the set point of ozone is detected. It also comes with 2 extra prefilters.
Room size: up to 10,000 cubic feet
Suggested installation Sanuvair® S1000 OZD
